Adding a partition in a restroom allows for multiple users at once.
Adding a partition can change the aesthetics of a restroom completely, adding privacy, and allowing for greater use. With a partition, generally separating the toilet from the wash area of the restroom, two can use the bathroom at the same time. For this reason, a restroom partition is particularly useful in a smaller home with few bathrooms. However, in any size home, a partition is a nice addition.
Instructions
Determine Location and Size
1. Determine where you want the partition in your restroom and what size it should be. This can be done most effectively by using graph paper and making a scale model of your bathroom. That way, you can experiment with different size partitions on paper until you determine the correct size. Write down the length and height of the partition. When decided, mark the partition out on the floor with a permanent marker. Remember that partition heights can vary and don't have to reach all the way to the ceiling, depending on the amount of privacy that you desire.
2. Build the partition wall on the ground first and then lift into place nailing two 2-by-4's together on the outside for strength. Place the base 2-by-4 down first (length) and screw the long (height) 2-by-4's into the base at 8-inch intervals. When done, place the topper 2-by-4 on top and screw into place.
3. Stand the partition up and line it up with your markings on the floor. Depending on the size of the partition, you may need help. Once in place, hold it and the floor and wall. , if partition reaches to the ceiling, screw into the ceiling.
4. Cut the drywall to fit the partition walls using the razor blade cutter and a straightedge. Cut one side first and bend the drywall to break it, then flip it over, cutting the other side. Screw the drywall onto the partition using drywall screws, ensuring the screws go into the studs.
5. Tape the drywall at the seams and the corners tape. Once the tape is set, use joint compound and a metal drywall knife to cover the seams. Use light coats and let dry, keeping them as smooth as possible. After several coats, smooth over rough spots with a clean, dry rag dipped in water. Let dry completely. Once dry, paint wall.
Tags: screw into, Adding partition, , using drywall, When done